Comb Communications MKII Manuel d'utilisateur télécharger pdf (Page 18)

Page 18 of 56

STEP 6

Step 6 is a mandatory step. You need to add the amount of units, which the complex

requires.

At first, type in the number of units that you wish to add and then type in the Starting

code. The starting code is the number that you wish your units to start at e.g. add 10

units to start at 100, your numbering will be 100, 101, 102 etc. Now you need to select

the set of gate trigger defaults that the units are to use to trigger the gate i.e if you are

not using the Default settings (for more information on Gate Trigger Defaults refer to

Chapter 11). Once all the information is captured click on the Add button.

You will notice that the information that you have entered will now appear in the

middle of the context window under the pending section.

This gives you the ability to add multiple units starting at different numbers. Just below

the pending section is a Current section, this displays what units are currently in use

at the complex. Once you have added all the units, proceed to step 7.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Pas de commentaire

Comb Communications MKII Manuel d'utilisateur Page 18